Hi Guys,
Wasn't sure where to post this, and DIY seemed appropriate.
A couple of questions about my router, first one I've had.
When I plunge the router it stops where the red line is
![](http://www.imageupload.co.uk/images/2015/05/21/00FullyupPS_resize.th.jpg)
![](http://www.imageupload.co.uk/images/2015/05/21/01Fullydown_resize.th.jpg)
..is this right? Or is it supposed to plunge further?
The reason I'm asking this is I thought that "50mm plunge depth" meant that the cutting bit would cut down to a depth of 50mm?
Where as currently when the router is fully plunged / depressed the cutting bit only cuts to a depth of 20mm
Can anyone set me straight on this matter please?
Thanks for reading my post,
JD
Wasn't sure where to post this, and DIY seemed appropriate.
A couple of questions about my router, first one I've had.
When I plunge the router it stops where the red line is
![](http://www.imageupload.co.uk/images/2015/05/21/00FullyupPS_resize.th.jpg)
![](http://www.imageupload.co.uk/images/2015/05/21/01Fullydown_resize.th.jpg)
..is this right? Or is it supposed to plunge further?
The reason I'm asking this is I thought that "50mm plunge depth" meant that the cutting bit would cut down to a depth of 50mm?
Where as currently when the router is fully plunged / depressed the cutting bit only cuts to a depth of 20mm
Can anyone set me straight on this matter please?
Thanks for reading my post,
JD
Comment